SETUP MENU C - Rudder pulse width

From BEASTX Wiki
Jump to: navigation, search
This page is a translated version of the page Manuals:MBPlusFblV5:Setupmenu C and the translation is 100% complete.


With Setup menu point C you define the (center) pulse width for the rudder servo. Almost all available rc servos work with 1500 - 1520 μs. But there are a few special rudder servos on the market which use a different center position pulse length.

Xservo 980.png

Here you can find a list of parameters for the most common servos. Please understand that we can not list all servo types. If a servo needs a special pulse length this usually is mentioned in the data sheet of the servo, mentioned on the packaging or directly printed on the servo. Ask the manufacturer of the servos or your local dealer for detailed information. If in doubt about the center pulse for your servo use the setting 1520 μs. It is very likely that the servo will work with this pulse length. Also when the servo is rated with 1500 μs center pulse use this setting. There is barely any difference between 1500 and 1520 μs and the operating pulse range is nearly the same, so these servos are all of the same type.

There is a relationship between the setting of the rudder servo center pulse length and the (rudder frequency). For technical reason only special gyro servos with 760µs pulse width can be used with frequencies higher than 333Hz, as standard pulse width would be too long and would not fit into the pulse!




Adjustment on the device

To select the desired rudder servo pulse width (servo type) move the rudder stick repeatedly in one direction until the Status-LED lights in the correct color at SETUP MENU point C:

Status-LED Rudder servo center pulse length
purple 760
red 960
blue 1520

Note: When you've set a different pulse width using the StudioXm App the Status LED will be off. You can change back to a preset setting by tapping the rudder stick as described, but this will remove your custom setting!


Setup with StudioXm

Choose a preset rudder pulse width by clicking one of the provided buttons for Menu Point C (Rudder pulse width) or set a custom pulse width by directly changing the value with the dial or buttons.

x250px