SETUP MENU I - Servo directions
At SETUP MENU point I move the collective pitch on the transmitter and change the servo directions so that all servos are moving the swashplate up and down together (the other functions are disabled here, as they are not of interest at this setup step!). After adjusting servo directions make sure that the pitch direction is correct! You can either do this by setting the servo directions correctly right from the beginning or by changing the direction of the pitch channel in the transmitter later.
Please note: Usually you can not reverse the servos with the servo reverse function of your transmitter! The transmitter only controls the functions of MICROBEAST PLUS, not the servos! Reversing a channel in the transmitter will only reverse the control function in total. There is one exception: with mechanical mixing (mCCPM) each servo is controling one function, so actually here you can reverse the servos also be reversing the sticks/functions in the transmitter. Because of this, the servo reversing in MICROBEAST PLUS is not necessary and not provided when using the mCCPM swash type! SETUP MENU point I will be skipped in this case.
Adjustment on the device
By tapping the aileron stick you can select one servo after another. Every color of the Status-LED is corresponding to a specific servo channel that is indicating its selection by a short up and down move. Tap the rudder stick once to change the servo direction. You can switch back and forth between the servos as often as you need.
|purple||CH1 – elevator servo|
|red||CH2 – aileron(1) servo|
|blue||CH3 – aileron(2)|
|red/blue||CH7 – elevator servo(2) (90° eCCPM only)|
Setup with StudioX
To activate the servo directions adjustments click the Adjust button in the corresponding table row (when using the Wizard function this will be done automatically when you click the Next button after adjusting Menu Point H). For your reference the servos will briefly move up and down once one after another in the given order CH1 to CH3 (CH7) so you can identify them easily. Set servo direction for each servo as necessary and make sure the pitch is moving correctly as described above. Finally click the Save button or Next button (when using the Wizard function) to finish the adjustment.
Setup with StudioXm
When the adjustment screen appears, for your reference the servos will briefly move up and down once one after another in the given order CH1 to CH3 (CH7) so you can identify them easily. Set servo direction for each servo as necessary and make sure the pitch is moving correctly as described above.