Translations:Manuals:AR7210FblV5:Parametermenu/4/en

Setup with StudioX

Please note that editing parameters is only possible when the device has initialized completely. So as long as the system is not in operation mode the button to open the "Parameters" section is greyed out. If it does not pass initialization sequence check the device status shown in the middle of the screen. If the system does not finish "Receiver init" check the receiver settings and radio setup. If the system does not finish "Sensor init" make sure that it is perfectly standing still and that power supply is stable.

Click the "Parameters" button. You will find the special parameters mentioned above under "Bank 1 - Parameters". You can edit them using the given adjustment buttons. When using the bank switching feature (only with PROEDITION firmware) you can set parameters for banks 2 and 3 accordingly and switch between those different settings in flight. When bank switching is deactivated you can only set parameters for bank 1 as this is the default bank.