Changes

__TOC__

__TOC__

<translate>

<translate>

{{DISPLAYTITLE:Questions about receivers and using them with MICROBEAST / MICROBEAST PLUS|noerror}}

{{DISPLAYTITLE:Questions about receivers and using them with MICROBEAST / MICROBEAST PLUS|noerror}}

<br />

<br />

==SPEKTRUM receiver with SRXL signal output==

==SPEKTRUM receiver with SRXL signal output== <!--T:2-->

''I'm using firmware 3.2.0 (or greater) which is stated to support the SRXL serial wire signal but MICROBEAST PLUS does not recognize my SPEKTRUM receiver at Receiver setup menu point '''B''' (Status LED stays red).''<br />

''I'm using firmware 3.2.0 (or greater) which is stated to support the SRXL serial wire signal but MICROBEAST PLUS does not recognize my SPEKTRUM receiver at Receiver setup menu point '''B''' (Status LED stays red).''<br />

<br />

<br />

<br />

<br />

==I get a red Status LED signal at Receiver menu point B==

==I get a red Status LED signal at Receiver menu point B== <!--T:3-->

Red Status LED at menu point B shows that the system is not receiving valid channel data or no data at all. This can have several reasons:

Red Status LED at menu point B shows that the system is not receiving valid channel data or no data at all. This can have several reasons:

* Check that you've selected the correct receiver type / transmission protocol at Receiver menu point A.

* Check that you've selected the correct receiver type / transmission protocol at Receiver menu point A.

<br />  

<br />  

==MICROBEAST / MICROBEAST PLUS with single SPEKTRUM remote satellite on large helis==

==MICROBEAST / MICROBEAST PLUS with single SPEKTRUM remote satellite on large helis== <!--T:4-->

''Why is using a single SPEKTRUM remote satellite only recommended for helis equal or smaller than 450 size?''<br />

''Why is using a single SPEKTRUM remote satellite only recommended for helis equal or smaller than 450 size?''<br />

<br />

<br />