Translations:Manuals:MB Plus:Governor usage/4/en

Note for using the nitro governor with separate switch channel

Some transmitters offer a special setting that allows to automatically switch the auxiliary governor channel together with the flight mode switch. So the motor can be ignited in the first flight mode and you can spool up the rotor and hover the heli by applying throttle manually. With the second flight mode the throttle curve is a "V"-shaped curve and simultaneously the RPM Governor is turned on by the auxiliary channel. In this case pay special attention that the two throttle curves/throttle positions match as good as possible in the stick point at which you usally switch flight modes. Otherwise the throttle servo would make a jump before the RPM Governor will take over control as you still may be in manual mode for a short amount of time. So in this type of operation it is not possible to activate the RPM governor from idle position and let the rotor spool up autonomously. If you want this, you must activate the RPM Governor before switching to your second flight mode with an additional switch!