7,261
edits
Changes
Jump to navigation
Jump to search
Line 71:
Line 71: − + + + + + + + + + + + + + + + + +
Importing a new version from external source
|}<br />
|}<br />
<br />
<br />
{{QUOTE|Note you must go through the complete receiver setup menu until you reach the menu end (all Menu LEDs flashing). Otherwise your settings will not be stored.}}
{{QUOTE|Note you must go through the complete receiver setup menu until you reach the menu end (all Menu LEDs flashing). Otherwise your settings will not be stored.}}<br />
<br />
<br />
Now power off and on again. MICROBEAST PLUS will perform initialization sequence. When the init is finished perform basic setup procedure (if not already done). When the heli is ready to fly open Parameter menu by briefly pushing the button while in operation mode and directly go to menu point L by skipping the other menu points pushing the button repeatedly. At menu point L choose your desired AttitudeControl mode and save it by again pushing the button briefly. If using a AttitudeControl mode with collective pitch input you may change the pitch at menu point M. When out of the Parameter menu check if AttitudeControl reacts correctly when flipping your AttitudeControl switch.<br />
<br />
{|class="gallery"
|-
|width="200pt" style="padding:0px 20px;"|[[Image:IMG 3222.JPG|192px|none|border]]
|width="300pt" style="padding:0px 20px;" align="center"|[[Image:IMG 3219.JPG|192px|none|border]]
|width="300pt" style="padding:0px 20px;" align="center"|[[Image:IMG 3228.JPG|192px|none|border]]
|width="200pt" style="padding:0px 20px;"|[[Image:IMG 3226.JPG|192px|none|border]]
|-
|width="200pt" style="padding:0px 20px;"|Flipping the switch into one direction AttitudeControl is on. This is shown by Menu LED N lighting up while the Status LED is red.
|width="200pt" style="padding:0px 20px;"|Flipping the switch to OFF position, Menu LED A will flash while the Status LED is red. If the switch reacts inverted use your transmitter's servo reverse function and reverse channel 7!
|width="200pt" style="padding:0px 20px;"|When Menu LED N lights up in ON position this probably is too much AttitudeControl gain. Use the transmitter's endpoint adjustment feature to decrease the amount of AttitudeControl gain.
|width="200pt" style="padding:0px 20px;"|As a good starting point Menu LED G should light up, which is reached with apprx. 50% servo throw on channel 7.
|}<br />
<br />
{{QUOTE|Don't forget: AttitudeControl gain and status will only be shown each time after the gain changes which is the case when flipping the switch. After 8 seconds the Menu LED will go off and the Status LED color changes back to blue or purple showing the tail gyro mode.}}<br />
===Setting up AttitudeControl using the gyro gain channel===
===Setting up AttitudeControl using the gyro gain channel===