BEASTX StudioX Computer and mobile App

From BEASTX Wiki
Revision as of 16:27, 26 February 2018 by Shornstein (talk | contribs)
Jump to navigation Jump to search


This site is stil under construction, thank you for your patience!'



StudioX / StudioXm is the app that allows to fully configure your MICROBEAST PLUS, Spektrum AR7210BX and NANOBEAST (coming soon). You can use it to do all the configuration from the computer or smartphone, to backup settings, load preconfigured setups and do a lot more. Please note for older device like MICROBEAST, AR7200, AR7300 you must use StudioX Version 2.2.4, as well as when you have a MICROBEAST PLUS or SPEKTRUM AR72120BX with firmware version 4.x.x or lower. Instructions for the old (deprecated) StudioX Version 2 can be found by clicking here.


StudioX in combination with PC/mac and USB2SYS computer interface



StudioXm in combination with smartphone and BLE2SYS Bluetooth Smart interface

If not already done power up radio and MICROBEAST PLUS. Connect the BLE2SYS interface to the [SYS] port. Then click "Connect button" on the start screen of StudioXm when the BLE2SYS is found (for further information refer to the StudioXm instructions). Wait until the data is loaded from the device and initialization sequence is finished. At first the system will calibrate to the radio system, Menu LEDs H to N will cycle up and down at the device and you can read "Radio init" in the opening overview size. During this time do not move the sticks on your radio as the system is learning the stick mid positions. In the second step MICROBEAST PLUS checks if the sensors are working correctly and learns the sensor rest positions. Here Menu LEDs A to G will cycle up and down and you can read "Sensor init" in the opening overview size. During this time do not move the helicopter. When initialization is completed the Status LED will change to blue or purple color indicating the current gyro mode and you can read the gyro gain and mode in the App. If you can't get through the initialization sequence either because LEDs A-G or LEDs H-N don't stop cycling please read the FAQ. Note that during initialization pressing the button has no significant effect and you will not be able to enter any menu.