Translations:Manuals:MBPlusFblV5:ReceiverType/22/en

Point A - Receiver type

In order to detect the connected receiver type make sure the receiver is bound to the transmitter and sending out signals. Also make sure the transmitter is setup correctly as shown in the chapter Radio System. Press the "Scan" button to start automatic receiver detection routine. The Status-LED on the device and the display will indicate which type the system is scanning for at the moment. When a valid input signal was detected the receiver type will be set automatically and a small dialog will appear and ask you how to proceed with function assignments in case a single-line receiver is used or the system will restart when a Standard receiver is used. When detection fails the system will stay at menu point A. In this case once again make sure your receiver is connected properly to MICROBEAST PLUS, bound to the transmitter and sending out control signals and try again.