Translations:Manuals:MB Plus:Receiver setup menu N/2/en

From BEASTX Wiki
Revision as of 09:21, 2 July 2015 by FuzzyBot (talk | contribs) (Importing a new version from external source)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

test

 

test

test


This completes the receiver setup and the MICROBEAST PLUS will go into sleep state after the button is pressed (all Menu-LEDs flash). Power off the unit and power it again. It will start with the standard initialization procedure and if the adjustments of Receiver setup menu have been set correctly, the unit will recognize your receiver and control channels now. You can see this by the circulating LED row on the right side (Menu-LEDs H-N). When the receiver initialization is finished the row will disappear and change to circulation of Menu-LEDs A-G that shows sensor initialization is running. If this is finished too, MICROBEAST PLUS will go into operation mode and you may proceed with basic setup of your helicopter.