(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Here you find a list of servo specifications so you can see what you have to adjust at SETUP MENU points B,C and D when doing the EasySetup at the device. Please note that not all of these specifications have been tested and validated by BEASTX. Some have been directly taken from the manufacturer recommendations in accordance with the maximum specified frequency.
Note that the servos may overheat and get damaged if the frequency is set to high! Depending on height of supply voltage, servo load, vibration level and other factors it can happen that practically the frequency must not be set as high as "written on the paper". When a frequency is not "supported" by MICROBEAST/MICROBEAST PLUS simply use the lower frequency that is closest or set the frequency with the StudioX Software or StudioXm App.
