FuzzyBot: Importing a new version from external source

2016-03-04T11:42:36Z

Importing a new version from external source

← Older revision		Revision as of 11:42, 4 March 2016
Line 1:		Line 1:
	{{QUOTE\|'''Note for AR7200BX/Ar7300BX (not AR7210BX):''' If Parameter menu point '''B''' is set to preset "blue" and the tail gain is switched to heading lock mode you can see in operation mode by the Status LED state at which tail stick position the maximum possible rotation rate on rudder will be reached: At that specific tail stick position the Status LED will start to flash. Moving the stick to this point in flight the rotation rate of the helicopter will be as high as the gyro can control. Increasing the stick throw further the LED will go off. At this point the rate control is switched off and the rudder axis will spin uncontrolled. Here the only limit is the tail pitch throw and ~~normaly~~ the tail will spin ultra fast. This can be used for performing tail slides or turns with very fast spinning tail. For normal flying around you should not use this as you may ~~accidentaly~~ steer into the uncontrolled area and the tail may spin too fast or very uneven. So please check on the ground that the Status LED will not go off when giving full rudder stick deflection in your default flight modes.}}<br />		{{QUOTE\|'''Note for AR7200BX/Ar7300BX (not AR7210BX):''' If Parameter menu point '''B''' is set to preset "blue" and the tail gain is switched to heading lock mode you can see in operation mode by the Status LED state at which tail stick position the maximum possible rotation rate on rudder will be reached: At that specific tail stick position the Status LED will start to flash. Moving the stick to this point in flight the rotation rate of the helicopter will be as high as the gyro can control. Increasing the stick throw further the LED will go off. At this point the rate control is switched off and the rudder axis will spin uncontrolled. Here the only limit is the tail pitch throw and normally the tail will spin ultra fast. This can be used for performing tail slides or turns with very fast spinning tail. For normal flying around you should not use this as you may accidentally steer into the uncontrolled area and the tail may spin too fast or very uneven. So please check on the ground that the Status LED will not go off when giving full rudder stick deflection in your default flight modes.}}<br />

FuzzyBot: Importing a new version from external source

2015-11-06T17:00:45Z

Importing a new version from external source

New page

{{QUOTE|'''Note for AR7200BX/Ar7300BX (not AR7210BX):''' If Parameter menu point '''B''' is set to preset "blue" and the tail gain is switched to heading lock mode you can see in operation mode by the Status LED state at which tail stick position the maximum possible rotation rate on rudder will be reached: At that specific tail stick position the Status LED will start to flash. Moving the stick to this point in flight the rotation rate of the helicopter will be as high as the gyro can control. Increasing the stick throw further the LED will go off. At this point the rate control is switched off and the rudder axis will spin uncontrolled. Here the only limit is the tail pitch throw and normaly the tail will spin ultra fast. This can be used for performing tail slides or turns with very fast spinning tail. For normal flying around you should not use this as you may accidentaly steer into the uncontrolled area and the tail may spin too fast or very uneven. So please check on the ground that the Status LED will not go off when giving full rudder stick deflection in your default flight modes.}}<br />

Translations:Help:FAQ Spektrum/34/en - Revision history

FuzzyBot: Importing a new version from external source

FuzzyBot: Importing a new version from external source