https://wiki.beastx.com/index.php?action=history&feed=atom&title=Translations%3AManuals%3ABXFbl%3ARadio_Setup%3AFutaba_SBUS%2F16%2Fen 2026-05-11T10:28:41Z Revision history for this page on the wiki MediaWiki 1.42.1 https://wiki.beastx.com/index.php?title=Translations:Manuals:BXFbl:Radio_Setup:Futaba_SBUS/16/en&diff=22752&oldid=prev 2024-04-09T14:28:10Z

<p>Importing a new version from external source</p> <p><b>New page</b></p><div>==MICROBEAST PLUS / MICROBEAST ULTRA==<br /> Push and hold the button on your MICROBEAST and power up the device. Menu LED A will flash instantly. Now release the button. Push again to start the scan process. When scan was successful, Menu LED B will show up. Now push and hold the button for 2 seconds and release in order to load the default channel assignments. If needed you can set up your telemetry devices at Menu LEDs L &amp; M, if applicable; push button briefly to skip. Finally teach throttle failsafe position at Menu LED N by bringing the throttle in lowest position on your radio and push the button again. Now your MICROBEAST will start with init sequence.<br /> For further information about RECEIVER MENU setup, see next section. Then perform basic setup procedure in SETUP MENU.&lt;br /&gt;<br /> &lt;br /&gt;<br /> &lt;br /&gt;</div>

FuzzyBot