FuzzyBot: Importing a new version from external source

2023-03-02T14:45:28Z

Importing a new version from external source

← Older revision		Revision as of 14:45, 2 March 2023
Line 4:		Line 4:
	[[File:Receiver_setup_1.png\|x180px\|none]]<br />		[[File:Receiver_setup_1.png\|x180px\|none]]<br />
	<br />		<br />
	In order to detect the receiver you're using, make sure the receiver is connected properly, bound to the radio and sending out signals. Also make sure the transmitter is setup correctly as shown in the chapter [[Manuals:~~MBULTRAFblV52~~:Radio_System/en\|Radio System]]. Then briefly press the button to start automatic receiver detection routine. The Status LED will indicate the scan process:<br />		In order to detect the receiver you're using, make sure the receiver is connected properly, bound to the radio and sending out signals. Also make sure the transmitter is setup correctly as shown in the chapter [[Manuals:MBUltraFblV5:Radio_System/en\|Radio System]]. Then briefly press the button to start automatic receiver detection routine. The Status LED will indicate the scan process:<br />
	<br />		<br />
	{\|cellpadding="4" cellspacing="0" border="1"		{\|cellpadding="4" cellspacing="0" border="1"

FuzzyBot: Importing a new version from external source

2023-03-02T14:40:06Z

Importing a new version from external source

New page

=Adjustment on the device=
To get into the RECEIVER MENU press the button on MICROBEAST ULTRA and hold it down before(!) and while turning on the receiver power supply. The yellow Menu LEDs start to cycle immediately. When you release the button, Menu LED '''A''' will be flashing and the color of the Status LED will indicate the receiver type that is selected at the moment. 
 
[[File:Receiver_setup_1.png|x180px|none]] 
 
In order to detect the receiver you're using, make sure the receiver is connected properly, bound to the radio and sending out signals. Also make sure the transmitter is setup correctly as shown in the chapter [[Manuals:MBULTRAFblV52:Radio_System/en|Radio System]]. Then briefly press the button to start automatic receiver detection routine. The Status LED will indicate the scan process: 
 
{|cellpadding="4" cellspacing="0" border="1"
!style="width:100px; text-align:left;" | Status-LED !! Receiver type/protocol
|-
|style="color:white; background-color:black"{{!}}off
|Standard receiver
|-
|style="color:white; background-color:#CC66CC"{{!}}purple
|Receiver at remote port
|-
|style="color:white; background-color:#FF3300"{{!}}red
|No receiver detected
|-
|style="color:white; background-color:#0066FF"{{!}}blue
|Receiver at port IO1
|} 
* In case a single-line receiver is used, the system will skip to Menu Point '''B''' when a valid input signal was detected.
* When a Standard receiver is used, the system will exit and restart immediately.
* When detection fails, the system will stay at Menu Point '''A''' and the Status LED will flash in red color. Once again, make sure your receiver is connected properly to MICROBEAST ULTRA, make sure the receiver is bound to the transmitter and sending out control signals. Then please try again. 
{{NL}}

Translations:Manuals:MBUltraFblV5:Receiver A/3/en - Revision history

FuzzyBot: Importing a new version from external source

FuzzyBot: Importing a new version from external source