FuzzyBot: Importing a new version from external source

2023-03-09T10:05:40Z

Importing a new version from external source

New page

=Setup with StudioX=
To teach the failsafe position choose "Proceed" when asked to teach the failsafe position and set the throttle channel on your remote control to the desired position. Then press '''Set''' to save the position. If you did not connect a function to [IO2] or [IO1] output and don't need throttle failsafe, press '''Cancel''' to complete setup!<br />
<br />
<div class="iosgallery">
<img class="ios" src="https://wiki.beastx.com/images/studiox/freakware%202019-07-09%20025.PNG">
<div class="iostext">After function assignment click <b>Proceed</b> to start teaching the throttle failsafe position</div>
</div>
<div class="iosgallery">
<img class="ios" src="https://wiki.beastx.com/images/studiox/freakware%202019-07-09%20027.PNG">
<div class="iostext">Move throttle to lowest position at which the motor is turned off</div>
</div>
<div class="iosgallery">
<img class="ios" src="https://wiki.beastx.com/images/studiox/freakware%202019-07-09%20028.PNG">
<div class="iostext">Click <b>Set</b> to store the setting</div>
</div>
<br />
<br />
{{WARNING_QUOTE|'''During failsafe setting the [IO2] or [IO1] output is enabled and can be controlled by the transmitter channel that is assigned to throttle function.''' This allows to check your throttle position in reality. When using electric models make sure the motor is disconnected from the ESC or the pinion is removed from the motor, so that it will not drive the model by accident.
}}<br />
<br />
<br />

Translations:Manuals:MBUltraFblV5:Receiver N/3/en - Revision history

FuzzyBot: Importing a new version from external source