Bureaucrats, Administrators, translate-proofr
15,689
edits
Changes
Jump to navigation
Jump to search
Line 1:
Line 1: + + Line 11:
Line 13: − + Line 42:
Line 44: − + − +
Manuals:MBPlusFblV5:Governormenu E (view source)
Revision as of 14:45, 20 December 2017
, 6 years agoMarked this version for translation
<translate>
<translate>
<!--T:1-->
{{TOC_MBPlusV5}}
{{TOC_MBPlusV5}}
{{DISPLAYTITLE:Throttle signal divider|noerror}}
{{DISPLAYTITLE:Throttle signal divider|noerror}}
<!--T:2-->
When using electric motors the rpm sensor signal usually consists of the (electric) field speed. In order to obtain the actual engine speed the field speed must be divided by half the number of motor poles. Using a 2-pole motor thus the measured speed corresponds to the motor speed. With a 10-pole motor on the other hand the field speed is five times higher than the actual speed.
When using electric motors the rpm sensor signal usually consists of the (electric) field speed. In order to obtain the actual engine speed the field speed must be divided by half the number of motor poles. Using a 2-pole motor thus the measured speed corresponds to the motor speed. With a 10-pole motor on the other hand the field speed is five times higher than the actual speed.
Also for nitro/gas engines the measured speed of the sensor may be higher than the actual speed. For example when a magnetic sensor is installed and more than one magnets are used for measuring the rotational speed, the rpm output will be multiplied by the number of magnets. So when two sensor magnets are used the rpm signal from the sensor will be twice the engine revolutions. So in order the rotor speed matches the rotor speed you set with the transmitter you must specifiy the factor by how much the incoming rpm signal must be divided to get the actual motor rpm.<br />
Also for nitro/gas engines the measured speed of the sensor may be higher than the actual speed. For example when a magnetic sensor is installed and more than one magnets are used for measuring the rotational speed, the rpm output will be multiplied by the number of magnets. So when two sensor magnets are used the rpm signal from the sensor will be twice the engine revolutions. So in order the rotor speed matches the rotor speed you set with the transmitter you must specifiy the factor by how much the incoming rpm signal must be divided to get the actual motor rpm.<br />
<br />
<br />
=Adjustment on the device=
=Adjustment on the device= <!--T:3-->
At GOVERNOR MENU point E the currently selected division factor is represented by the color of the Status-LED. Use the rudder stick to switch between options.<br />
At GOVERNOR MENU point E the currently selected division factor is represented by the color of the Status-LED. Use the rudder stick to switch between options.<br />
<br />
<br />
<br />
<br />
=Setup with StudioX=
=Setup with StudioX= <!--T:4-->
<br />
<br />
<br />
<br />
<br />
<br />
=Setup with StudioXm=
=Setup with StudioXm= <!--T:5-->
<br />
<br />
<br />
<br />