Translations:Manuals:AR7210FblV5:Parametermenu/13/en

Throttle response (I)

Use PARAMETER MENU point I to change the response of the internal Governor control. This determines how fast and how far the system will open the throttle when the rotor speed changes. Ideally the response is set as high as possible. If it is too low, the main rotor will speed up in unloaded conditions as the system reduces throttle not quick enough. Also the internal Governor will increase throttle very cautious when the rotor is loaded, so that the head speed will drop. If on the other hand the response is set too high, the throttle may stutter audible and the throttle will kick in very hard. So the motor speed will overshoot when the rotor head is loaded. This will make the headspeed even more inconsistent than with a lower setting. The height of throttle response highly depends on factors such as heli size (blade size), motor power and performance and/or the throttle reponse behavior of the speed controller (when flying an electric heli). If you need to adjust the throttle response, we recommend to start with the lowest value and increase stepwise just until you get the most consistent rotor head speed. Having a heli with good motor power and a fast responding speed controller (on electric helis) typically allows to have high throttle response values (up to "very aggressive" setting) which will give very consistent head speed. Helis with not so much power (small nitros, gasser, scale helis) prefer low throttle response settings for a softer throttle management.

Status-LED	Throttle response
off	soft
purple	normal
red flashing	slightly increased
red	increased
blue flashing	aggressive
blue	very aggressive