7,309
edits
Changes
Jump to navigation
Jump to search
Line 1:
Line 1: + + + + +
Translations:Help:StudioX:Bootloader/1/en (view source)
Revision as of 07:59, 7 December 2022
, 1 year agoImporting a new version from external source
{{DISPLAYTITLE:Bootloader mode|noerror}}
In case the firmware update does not start to run in StudioX, please try to flash your device from bootloader mode. To enter boot mode you need a jumper wire or modified Spektrum bind plug with two ports next to each other. Then you need a battery or BEC supply to power the Beastx unit. See attached pictures (in the example we use a SPEKTRUM AR7210BX but this applies to any BEASTX device accordingly).<br />
In case the firmware update does not start to run in StudioX, please try to flash your device from bootloader mode. To enter boot mode you need a jumper wire or modified Spektrum bind plug with two ports next to each other. Then you need a battery or BEC supply to power the Beastx unit. See attached pictures (in the example we use a SPEKTRUM AR7210BX but this applies to any BEASTX device accordingly).<br />
<br />
<br />
1. You need to bridge the upper pin of SYS port with the pin on the right hand side using the jumper wire or modified bind plug. If nothing else is at hand you even could bridge it with a screw driver or similar but be careful not to touch "+" or "-".<br />
1. You need to bridge the upper pin of SYS port with the pin on the right hand side using the jumper wire or modified bind plug. If nothing else is at hand you even could bridge it with a screw driver or similar but be careful not to touch "+" or "-".<br />
{|-
|[[File:Boot jumper.jpg|x300px|none]]
|[[File:Boot powerup.jpg|x300px|none]]
|}
<br />
<br />
2. Power on the BEASTX unit. The red LED will display immediately.<br />
2. Power on the BEASTX unit. The red LED will display immediately.<br />