7,309
edits
Changes
Jump to navigation
Jump to search
Line 1:
Line 1: − ===1. Uninstall existing Software (Windows only)===+ − Uninstall any existing BEASTXUpdater/Microsettings installation prior to install the BEASTXSoftware bundle. Line 15:
Line 14: − ===3. Driver installation===+ − Windows: − The driver installation will not be launched automatically during setup. − The installer will be copied and a link to it is added to the BEASTX group in Start-Menu. Do not connect the USB2SYS interface to the computer unless you did not perform the driver installation. After the installation when you connect the interface to the PC, Windows will recognize the device and install it as a new device. Line 28:
Line 24: − ===4. Validate driver installation (Windows only)===+ − After successful installation of the driver, when the USB2SYS-Interface is connected to the PC, you must be able to find following entry in the Windwos Device Manager: Line 40:
Line 35: − ===5. Start BEASTXUpdater===+ − IMPORTANT: The MICROBEAST will not be powered from the USB2SYS-Interface, so the MICROBEAST must be supplied with power from a different source BEFORE you connect it to the PC, e.g. simply switch on tx and rx as you would go flying (on electric helis take care of the motor!). Line 115:
Line 109: − ===8. Perform Update===+ − If a valid COM-Port is selected an a valid Update-File was loaded, the "Start Update…" button will be enabled:
Importing a new version from external source
<languages />
<languages />
<br />
<br />
'''1. Uninstall existing Software (Windows only)'''
Uninstall any existing BEASTXUpdater/Microsettings installation prior to install the BEASTXSoftware bundle.
Uninstall any existing BEASTXUpdater/Microsettings installation prior to install the BEASTXSoftware bundle.
'''3. Driver installation'''
Windows:
Windows:
'''4. Validate driver installation (Windows only)'''
After successful installation of the driver, when the USB2SYS-Interface is connected to the PC, you must be able to find following entry in the Windwos Device Manager:
After successful installation of the driver, when the USB2SYS-Interface is connected to the PC, you must be able to find following entry in the Windwos Device Manager:
'''5. Start BEASTXUpdater'''
IMPORTANT: The MICROBEAST will not be powered from the USB2SYS-Interface, so the MICROBEAST must be supplied with power from a different source BEFORE you connect it to the PC, e.g. simply switch on tx and rx as you would go flying (on electric helis take care of the motor!).
IMPORTANT: The MICROBEAST will not be powered from the USB2SYS-Interface, so the MICROBEAST must be supplied with power from a different source BEFORE you connect it to the PC, e.g. simply switch on tx and rx as you would go flying (on electric helis take care of the motor!).
'''8. Perform Update'''
If a valid COM-Port is selected an a valid Update-File was loaded, the "Start Update…" button will be enabled:
If a valid COM-Port is selected an a valid Update-File was loaded, the "Start Update…" button will be enabled: