Device update/en: Difference between revisions

Jump to navigation Jump to search
← Older edit
FuzzyBot (talk | contribs)
8,014 edits
Importing a new version from external source
FuzzyBot (talk | contribs)
8,014 edits
Importing a new version from external source
 
(One intermediate revision by the same user not shown)
Line 14: Line 14:




===3. Driver installation===
'''3. Driver installation'''
Windows:
The driver installation will not be launched automatically during setup.
The installer will be copied and a link to it is added to the BEASTX group in Start-Menu. Do not connect the USB2SYS interface to the computer unless you did not perform the driver installation. After the installation when you connect the interface to the PC, Windows will recognize the device and install it as a new device.


Windows:
Windows:
Line 38: Line 35:




===5. Start BEASTXUpdater===
'''5. Start BEASTXUpdater'''
IMPORTANT: The MICROBEAST will not be powered from the USB2SYS-Interface, so the MICROBEAST must be supplied with power from a different source BEFORE you connect it to the PC, e.g. simply switch on tx and rx as you would go flying (on electric helis take care of the motor!).


IMPORTANT: The MICROBEAST will not be powered from the USB2SYS-Interface, so the MICROBEAST must be supplied with power from a different source BEFORE you connect it to the PC, e.g. simply switch on tx and rx as you would go flying (on electric helis take care of the motor!).
IMPORTANT: The MICROBEAST will not be powered from the USB2SYS-Interface, so the MICROBEAST must be supplied with power from a different source BEFORE you connect it to the PC, e.g. simply switch on tx and rx as you would go flying (on electric helis take care of the motor!).
Retrieved from "https://wiki.beastx.com/index.php?title=Device_update/en"