Manuals:MBPlusFblV52:Receiver N/en: Difference between revisions
Jump to navigation
Jump to search
Updating to match new version of source page |
Updating to match new version of source page |
||
| Line 6: | Line 6: | ||
=Adjustment on the device= | =Adjustment on the device= | ||
At Menu Point N of the RECEIVER MENU you teach the failsafe position for throttle channel. In case the receiver signal is interrupted during operation the throttle servo/speed controller connected to the [CH5] Output is automatically moved to this position. This particularly is the case: | At Menu Point N of the RECEIVER MENU you teach the failsafe position for throttle channel. In case the receiver signal is interrupted during operation the throttle servo/speed controller connected to the [CH5] Output is automatically moved to this position. This particularly is the case: | ||
* if using a single-line receiver that turns | * if using a single-line receiver that turns off the signal in case of signal loss between receiver and transmitter (e.g. Spektrum® satellite receiver or Graupner® HOTT receiver in „SUMDOF“ mode) | ||
* if the connection between MICROBEAST PLUS and receiver gets disconnected | * if the connection between MICROBEAST PLUS and receiver gets disconnected physically | ||
* during initialization when the transmitter | * during initialization phase when the transmitter is not switched on or was switched on too late and the radio link between transmitter and receiver is not established yet | ||
Additionally the failsafe position is used by the | Additionally the failsafe position is used by the Governor function in case you're using a helicopter with electric drive system. Here the throttle is moved to the stored failsafe position when you switch the Governor into Autorotation mode!<br /> | ||
<br /> | <br /> | ||
'''Note:''' | '''Note:''' | ||