Revision as of 13:10, 23 March 2023
Information about message (contribute ) This message has no documentation.
If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Manuals:MBUltraFblV5:Radio System )
== Single wire with telemetry == When using a telemetry receiver and an ESC with telemetry data connector, the ESC is connected to the '''[IO1]''' output. The telemetry data signal of the ESC is connected to '''[IO2]''' input.<br /> <br /> Spektrum® AVIAN ESC do not have a separate line for telemetry data. Here motor control and telemetry data is sent bidirectional on the main connection wire. For this we must connect the AVIAN ESC to the [SYS] port of MICROBEAST ULTRA, as the other connectors [IO1] and [IO2] can only work in one direction.<br /> <br /> You will get further information about connecting and setting up the speed controller in a later section!<br /> <br />
== Single wire with telemetry ==
When using a telemetry receiver and an ESC with telemetry data connector, the ESC is connected to the '''[IO1]''' output. The telemetry data signal of the ESC is connected to '''[IO2]''' input.<br />
<br />
Spektrum® AVIAN ESC do not have a separate line for telemetry data. Here motor control and telemetry data is sent bidirectional on the main connection wire. For this we must connect the AVIAN ESC to the [SYS] port of MICROBEAST ULTRA, as the other connectors [IO1] and [IO2] can only work in one direction.<br />
<br />
You will get further information about connecting and setting up the speed controller in a later section!<br />
<br />
Translation == Single wire with telemetry == When using a telemetry receiver and an ESC with telemetry data connector, the ESC is connected to the '''[IO1]''' output. The telemetry data signal of the ESC is connected to '''[IO2]''' input. (You will get further information about connecting the speed controller in a later section!)<br /> <br /> Single wire with telemetry
When using a telemetry receiver and an ESC with telemetry data connector, the ESC is connected to the [IO1] output. The telemetry data signal of the ESC is connected to [IO2] input. (You will get further information about connecting the speed controller in a later section!)