Latest revision as of 13:36, 31 October 2023
Information about message (contribute ) This message has no documentation.
If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Manuals:MBPlusFblV52:TailMotor )
For tail motor driven helicopters, there is a separate firmware available which takes the special features of a tail motor system into account. You can download the firmware via StudioX app by activating the "Tail motor" feature on the firmware update page. Please note that all data on your Microbeast will be reset if you install the "Tail motor" Firmware over the "Standard" Firmware. Also note the "Tail motor" firmware can only be used in conjunction with a sum signal receiver. The tail motor is activated by Microbeast from the throttle signal position or from the MICROBEAST governor function. This is only possible using a sum signal receiver.<br />
For tail motor driven helicopters, there is a separate firmware available which takes the special features of a tail motor system into account. You can download the firmware via StudioX app by activating the "Tail motor" feature on the firmware update page. Please note that all data on your Microbeast will be reset if you install the "Tail motor" Firmware over the "Standard" Firmware. Also note the "Tail motor" firmware can only be used in conjunction with a sum signal receiver. The tail motor is activated by Microbeast from the throttle signal position or from the MICROBEAST governor function. This is only possible using a sum signal receiver.<br />
<br />
{{WARNING_QUOTE| Attention! Please remove the main rotor and tail rotor blades from the helicopter in order to perform the update procedure and for further settings. There are some safety features integrated to prevent the motors from starting, but you'll never know...}}
<br />
After the update/reset: The firmware is preset so that it fits the Logo 200 / OMP M2 heli. Nevertheless, go through all the setting points step by step even if you're using one of those helicopters. In particular, the radio setup and the motor switches still need to be set correctly.<br />
<br />
<br /> Translation For tail motor driven helicopters, there is a separate firmware available which takes the special features of a tail motor system into account. You can download the firmware via StudioX app by activating the "Tail motor" feature on the firmware update page. Please note that all data on your Microbeast will be reset if you install the "Tail motor" Firmware over the "Standard" Firmware. Also note the "Tail motor" firmware can only be used in conjunction with a sum signal receiver. The tail motor is activated by Microbeast from the throttle signal position or from the MICROBEAST governor function. This is only possible using a sum signal receiver.<br /> For tail motor driven helicopters, there is a separate firmware available which takes the special features of a tail motor system into account. You can download the firmware via StudioX app by activating the "Tail motor" feature on the firmware update page. Please note that all data on your Microbeast will be reset if you install the "Tail motor" Firmware over the "Standard" Firmware. Also note the "Tail motor" firmware can only be used in conjunction with a sum signal receiver. The tail motor is activated by Microbeast from the throttle signal position or from the MICROBEAST governor function. This is only possible using a sum signal receiver.
Attention! Please remove the main rotor and tail rotor blades from the helicopter in order to perform the update procedure and for further settings. There are some safety features integrated to prevent the motors from starting, but you'll never know...
