Translations:Manuals:BXFbl:Radio Setup:SRXL2/4/en: Difference between revisions
Jump to navigation
Jump to search
Importing a new version from external source |
(No difference)
|
Latest revision as of 14:27, 9 April 2024
For bi-directional telemetry connect the SRXL2 signal wire either to the SYS port or to the DI2 port of your MICROBEAST PLUS / ULTRA. When using the DI2 port an adapter from standard servo connector to 5-pin JST is required as shown below. Or you can use the original 4-pin wire that comes with your SPEKTRUM® receiver. In this case please note the the wire must be modified as shown below!