Translations:Manuals:BXFbl:Receiver M/8/en: Difference between revisions

From BEASTX Wiki
Jump to navigation Jump to search
FuzzyBot (talk | contribs)
Importing a new version from external source
 
FuzzyBot (talk | contribs)
Importing a new version from external source
 
Line 1: Line 1:
=ESC connections=
=ESC connections=
In the following we will only mention connections to MICROBEAST PLUS and MICROBEAST PLUS / ULTRA. Due to the fact, that there are not much micro-sized ESCs available with telemetry output, we won't go into detail here as it's rarely needed. Basically you can also use telemetry with NANOBEAST if you've installed a firmware with telemetry support on that device. Here the telemetry signal will be connected to the [SAT] port in any configuration. Setup procedure is similar to MICROBEAST PLUS / ULTRA.
<br />
<br />

Latest revision as of 11:58, 5 July 2024

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Manuals:BXFbl:Receiver M)
=ESC connections=
In the following we will only mention connections to MICROBEAST PLUS and MICROBEAST PLUS / ULTRA. Due to the fact, that there are not much micro-sized ESCs available with telemetry output, we won't go into detail here as it's rarely needed. Basically you can also use telemetry with NANOBEAST if you've installed a firmware with telemetry support on that device. Here the telemetry signal will be connected to the [SAT] port in any configuration. Setup procedure is similar to MICROBEAST PLUS / ULTRA.
<br />

ESC connections

In the following we will only mention connections to MICROBEAST PLUS and MICROBEAST PLUS / ULTRA. Due to the fact, that there are not much micro-sized ESCs available with telemetry output, we won't go into detail here as it's rarely needed. Basically you can also use telemetry with NANOBEAST if you've installed a firmware with telemetry support on that device. Here the telemetry signal will be connected to the [SAT] port in any configuration. Setup procedure is similar to MICROBEAST PLUS / ULTRA.