Help:StudioX:HMSoft/de: Difference between revisions
Jump to navigation
Jump to search
Updating to match new version of source page |
Updating to match new version of source page Tags: Mobile edit Mobile web edit |
||
| Line 45: | Line 45: | ||
<div lang="en" dir="ltr" class="mw-content-ltr"> | <div lang="en" dir="ltr" class="mw-content-ltr"> | ||
At first enter: AT+ | At first enter: AT+MODE2<br /> | ||
The interface should reply: OK+Set:2<br /> | |||
<br /> | <br /> | ||
Then enter: AT+BAUD?<br /> | |||
The interface should reply: OK+Get:7<br /> | The interface should reply: OK+Get:7<br /> | ||
<br /> | <br /> | ||
In case it shows a different number, the baud rate is not set correctly.<br /> | |||
You can change the setting by entering the command: AT+BAUD7<br /> | You can change the setting by entering the command: AT+BAUD7<br /> | ||
The interface will reply: OK+Set:7<br /> | The interface will reply: OK+Set:7<br /> | ||
<br /> | <br /> | ||
</div> | </div> | ||
<div lang="en" dir="ltr" class="mw-content-ltr"> | <div lang="en" dir="ltr" class="mw-content-ltr"> | ||
If you like you can change the name of the device: AT+NAMEUSB2SYS<br /> | |||
The interface should reply: OK+Set:USB2SYS<br /> | |||
<br /> | |||
The interface | |||
<br /> | |||
<br /> | <br /> | ||
</div> | </div> | ||
<div lang="en" dir="ltr" class="mw-content-ltr"> | <div lang="en" dir="ltr" class="mw-content-ltr"> | ||
Finally | Finally enter: AT+MODE1<br /> | ||
<br /> | The interface should reply: OK+Set:1<br /> | ||
The interface should reply: OK+Set: | |||
<br /> | |||
<br /> | <br /> | ||
</div> | </div> | ||
| Line 80: | Line 71: | ||
<div lang="en" dir="ltr" class="mw-content-ltr"> | <div lang="en" dir="ltr" class="mw-content-ltr"> | ||
===Connection to StudioX app=== | ===Connection to StudioX app=== | ||
Now setup should be finished. Disconnect the device from the app and close the app completely. Power cycle you BLE2SYS and reconnect to the BEASTX | Now setup should be finished. Disconnect the device from the app and close the app completely. Power cycle you BLE2SYS and reconnect to the BEASTX system's SYS-port. The blue LED on BLE2SYS should be flashing steadily.<br /> | ||
<br /> | <br /> | ||
Start StudioX and search for the device ''BLE2SYS'', if needed (click '''Refresh'''). Then click the '''Connect''' button. The blue LED should light up steadily and you BEASTX system should connect now.<br /> | Start StudioX and search for the device ''BLE2SYS'', if needed (click '''Refresh'''). Then click the '''Connect''' button. The blue LED should light up steadily and you BEASTX system should connect now.<br /> | ||