During the trim procedure you can delete the just performed trimming by moving the rudder stick in any direction. All servos will be moved to the initial position from entering Parameter menu point A. Note that a subsequent reset to previous states is not possible! If the servo trimming was changed and Parameter menu point A is left, the servo positions will be saved permanently. You can only bring back the servos to the previos positions by manually trimming them back into the opposite direction.
The trimming of the rudder servo will be fully deleted when the tail rotor endpoints are readjusted at Setup menu point E!
The trimming of the rudder servo will be fully deleted when the tail rotor endpoints are readjusted at Setup menu point E!
