7,284
edits
Changes
Jump to navigation
Jump to search
Translations:Manuals:MB Plus:Governor usage/1/en (view source)
Revision as of 14:05, 26 May 2015
, 8 years agoImporting a new version from external source
{{DISPLAYTITLE: Usage of RPM Governor (optional)|noerror}}
{{TOC_MBPlus}}
{{QUOTE|Please note that the RPM Governor function is an optional feature and may not be accessible on all MICROBEAST PLUS devices.<br />
<br />
[[FILE:Warning.png|sub|18px]] In general the RPM Governor can only be switched on when MICROBEAST PLUS is ready for operation. During the initialization phase the signal from the throttle channel is passed directly to the throttle servo. Therefore (especially with electric models) make sure that during the initialization the throttle channel is set to „motor off“ position at the transmitter (not „Autorotation“!).<br />
<br />
[[FILE:Warning.png|sub|18px]] Note that if your receiver does not send a valid control signal to MICROBEAST PLUS within two seconds after power up, the throttle channel will be locked for security reasons. In this case [CH5] output will be set to motor failsafe position (set at Receiver menu point N). Only when MICROBEAST PLUS gets a valid signal from the receiver and the throttle stick is moved to the programmed failsafe position (or below) the throttle channel will be unlocked.<br />
<br />
[[FILE:Warning.png|sub|18px]] With nitro helicopters always ensure that the RPM Governor is disabled when you start the model. Otherwise the RPM Governor would drive the throttle servo up to the full throttle position and stay there as it tries to reach the demanded head speed. So always check the throttle servo position before starting the engine very carefully!}}
<br />
{{TOC_MBPlus}}
{{QUOTE|Please note that the RPM Governor function is an optional feature and may not be accessible on all MICROBEAST PLUS devices.<br />
<br />
[[FILE:Warning.png|sub|18px]] In general the RPM Governor can only be switched on when MICROBEAST PLUS is ready for operation. During the initialization phase the signal from the throttle channel is passed directly to the throttle servo. Therefore (especially with electric models) make sure that during the initialization the throttle channel is set to „motor off“ position at the transmitter (not „Autorotation“!).<br />
<br />
[[FILE:Warning.png|sub|18px]] Note that if your receiver does not send a valid control signal to MICROBEAST PLUS within two seconds after power up, the throttle channel will be locked for security reasons. In this case [CH5] output will be set to motor failsafe position (set at Receiver menu point N). Only when MICROBEAST PLUS gets a valid signal from the receiver and the throttle stick is moved to the programmed failsafe position (or below) the throttle channel will be unlocked.<br />
<br />
[[FILE:Warning.png|sub|18px]] With nitro helicopters always ensure that the RPM Governor is disabled when you start the model. Otherwise the RPM Governor would drive the throttle servo up to the full throttle position and stay there as it tries to reach the demanded head speed. So always check the throttle servo position before starting the engine very carefully!}}
<br />