Manuals:MB Plus:Setupmenu N/en: Difference between revisions
Jump to navigation
Jump to search
Importing a new version from external source |
Importing a new version from external source |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{TOC_MBPlus}} | {{TOC_MBPlus}} | ||
{{DISPLAYTITLE:Setup menu point N|noerror}} | {{DISPLAYTITLE:Setup menu point N|noerror}} | ||
'''This menu point is only accessible if you have installed the RPM Governor feature on your device and in case you're using a [[Manuals:MB_Plus:Receiver_Installation/en#Single-Line_receivers|single-line receiver]]. The RPM Governor function is not applicable when a [[Manuals:MB_Plus:Receiver_Installation/en#Standard_receivers|Standard receiver]] is used!'''<br /> | |||
<br /> | |||
At Setup menu point '''N''' you can choose between three different options: | At Setup menu point '''N''' you can choose between three different options: | ||
* '''no governor''' - the RPM Governor is not used. All control commands on the throttle channel will be passed to [CH5] output directly. | * '''no governor''' - the RPM Governor is not used. All control commands on the throttle channel will be passed to [CH5] output directly. | ||
* '''electric governor''' - select this option if your helicopter is powered by an electric motor and an electric speed controller is plugged into [CH5] output of MICROBEAST PLUS. MICROBEAST PLUS reads the rpm signal from the speed controller or a phase sensor and controls the rotor speed accordingly. Note that the controller itself must not be operated in a (heli specific) governor mode. The speed controller must process the incomming throttle signals and control the motor as direct and unfiltered as possible | * '''electric governor''' - select this option if your helicopter is powered by an electric motor and an electric speed controller is plugged into [CH5] output of MICROBEAST PLUS. MICROBEAST PLUS reads the rpm signal from the speed controller or a phase sensor and controls the rotor speed accordingly. Note that the controller itself must not be operated in a (heli specific) governor mode. The speed controller must process the incomming throttle signals and control the motor as direct and unfiltered as possible. | ||
* '''nitro governor''' - with this option MICROBEAST PLUS can govern the rotor rpm of a helicopter with nitro or gas engine. For this MICROBEAST PLUS controls the throttle servo which is connected to [CH5] output and that controls the carburetor of the engine. The motor rpm will be read from a magnetic or optical sensor that captures the rpm from the crankshaft of the motor, the clutch bell or the main gear. | * '''nitro governor''' - with this option MICROBEAST PLUS can govern the rotor rpm of a helicopter with nitro or gas engine. For this MICROBEAST PLUS controls the throttle servo which is connected to [CH5] output and that controls the carburetor of the engine. The motor rpm will be read from a magnetic or optical sensor that captures the rpm from the crankshaft of the motor, the clutch bell or the main gear. | ||
<br /> | <br /> | ||
| Line 23: | Line 24: | ||
<br /> | <br /> | ||
---- | ---- | ||
If the RPM Governor is deactivated (option '''no governor''') MICROBEAST PLUS will exit the Setup menu if you briefly press the button. Otherwise pressing the button will lead to [[Manuals:MB_Plus:Governormenu_A|Governor menu point '''A''']]! | If the RPM Governor is deactivated (option '''no governor''') MICROBEAST PLUS will exit the Setup menu if you briefly press the button. Otherwise pressing the button will lead to [[Manuals:MB_Plus:Governormenu_A|Governor menu point '''A''']] (after Menu LED '''N''' now Menu LED '''A''' will flash)! | ||
---- | ---- | ||