Translations:Frequently Asked Questions/33/de: Difference between revisions

From BEASTX Wiki
Jump to navigation Jump to search
Created page with ": Die einzelnen Phasen bei Parametermenü Punkt B sind eine Mischung aus Expo und einer bestimmten Drehrate. Da die eingestellten Werte nicht zahlengenau auf die unterschiedli..."
 
FuzzyBot (talk | contribs)
7,906 edits
m FuzzyBot moved page Translations:Help:FAQ/33/de to Translations:Frequently Asked Questions/33/de without leaving a redirect: Part of translatable page "Help:FAQ".
 
(No difference)

Latest revision as of 14:43, 17 December 2013

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Frequently Asked Questions)
The presets in parameter B are nothing else than different preset dualrate/expo curves inside the MB. When using these it is recommended not to change the output signal in the TX as especially when using expo this will bend, compress or stretch the curves leading to very strange flight behavior (it just is not like adding 5% of expo as the curves between TX and Microbeast will multiply and not sum together!) If you like the feeling of course you can do this. For example a slight increase in stick throw for increasing the roll rate will not significantly deform the Microbeast's internal curve and can be done with no problem. But easiest thing would be to switch flight behaviour to "blue=TX" and adjust the curves in your transmitter as you like (therefor I'd suggest to start with 70% D/R and 25% expo on cylic and 85% D/R and 40% expo on tail). When setting parameter B to "blue = TX" these internal curves in MB will be disabled. So 100% stick should give 100% rotation rate. This may vary depending on TX brand as any manufacturer use another signal output as maximum. So this can be at 107 or 110% or also at 95%. Manufacturers calculate expo curves different, so we can't tell you what our preset curves correspond to which TXs expo values as we use our own expo and there is no data available for comparing. We did outfly these values and programmed them in the source code so we can't tell what these are in Futaba or JR percentages.
Die einzelnen Phasen bei Parametermenü Punkt B sind eine Mischung aus Expo und einer bestimmten Drehrate. Da die eingestellten Werte nicht zahlengenau auf die unterschiedlichen Sendertypen passen empfehlen wir, falls eine eigene Einstellung per Fernsteuerung bevorzugt wird, Parameterpunkt B auf "blau" zu stellen, im Sender mit ca. 20 - 30% Expo zu beginnen (mit negativem Vorzeichen bei Futaba) und den Servoweg auf ca. 70-80% zu reduzieren und sich dann allmählich an das gewünschte Steuerverhalten heranzutasten.
Retrieved from "https://wiki.beastx.com/index.php?title=Translations:Frequently_Asked_Questions/33/de&oldid=764"