7,309
edits
Changes
Jump to navigation
Jump to search
Line 3:
Line 3: + + + +
Updating to match new version of source page
<br />
<br />
1. You need to bridge the upper pin of SYS port with the pin on the right hand side using the jumper wire or modified bind plug. If nothing else is at hand you even could bridge it with a screw driver or similar but be careful not to touch "+" or "-".<br />
1. You need to bridge the upper pin of SYS port with the pin on the right hand side using the jumper wire or modified bind plug. If nothing else is at hand you even could bridge it with a screw driver or similar but be careful not to touch "+" or "-".<br />
{|-
|[[File:Boot jumper.jpg|x300px|none]]
|[[File:Boot powerup.jpg|x300px|none]]
|}
<br />
<br />
2. Power on the BEASTX unit. The red LED will display immediately.<br />
2. Power on the BEASTX unit. The red LED will display immediately.<br />