Translations:Manuals:BXFbl:Receiver M/20/en: Difference between revisions

From BEASTX Wiki
Jump to navigation Jump to search
FuzzyBot (talk | contribs)
7,906 edits
Importing a new version from external source
 
FuzzyBot (talk | contribs)
7,906 edits
Importing a new version from external source
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
==OMP 65A ESC==
==OMP 65A ESC==
Connect the control wire of your OMP ESC to port [IO1]. Connect the pin labeled with "TX" from the ESC to the port [IO2] using a single servo wire with plugs on both sides. Optionaly you can connect the yellow wire for measuring the motor speed to the [RPM] input at MICROBEAST ULTRA, so that it is out of the way. For telemetry transmission it is not needed as the data will be included in the telemetry signal!<br />
Connect the control wire of your OMP ESC to port [IO1] / [DI1]. Connect the pin labeled with "TX" from the ESC to the port [CH5] / [IO2] using a single servo wire with plugs on both sides. Optionaly you can connect the yellow wire for measuring the motor speed to the [RPM] input at MICROBEAST PLUS / ULTRA, so that it is out of the way. For telemetry transmission it is not needed as the data will be included in the telemetry signal!<br />
<br />
Make sure the ESC is sending data with OMP telemetry data protocol. This is the factory setting of the ESC. Do not change the protocol to "SBUS2" or other! MICROBEAST ULTRA will convert the data into your radio's protocol as needed.<br />
<br />
<br />
<br />

Latest revision as of 11:58, 5 July 2024

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Manuals:BXFbl:Receiver M)
==OMP 65A ESC==
Connect the control wire of your OMP ESC to port [IO1] / [DI1]. Connect the pin labeled with "TX" from the ESC to the port [CH5] / [IO2] using a single servo wire with plugs on both sides. Optionaly you can connect the yellow wire for measuring the motor speed to the [RPM] input at MICROBEAST PLUS / ULTRA, so that it is out of the way. For telemetry transmission it is not needed as the data will be included in the telemetry signal!<br />
<br />

OMP 65A ESC

Connect the control wire of your OMP ESC to port [IO1] / [DI1]. Connect the pin labeled with "TX" from the ESC to the port [CH5] / [IO2] using a single servo wire with plugs on both sides. Optionaly you can connect the yellow wire for measuring the motor speed to the [RPM] input at MICROBEAST PLUS / ULTRA, so that it is out of the way. For telemetry transmission it is not needed as the data will be included in the telemetry signal!

Retrieved from "https://wiki.beastx.com/index.php?title=Translations:Manuals:BXFbl:Receiver_M/20/en&oldid=25000"