Translations:Manuals:BXFbl:Hardware Installation/7/en: Difference between revisions
Jump to navigation
Jump to search
Importing a new version from external source |
Importing a new version from external source |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
Make sure that the mounting platform is perpendicular to the main shaft! On the other hand it's not important that the unit is directly placed on all the rotation axis (which is nearly impossible). Also it's not important that the system is placed in parallel to the ground or not.<br /> | |||
<br /> | <br /> | ||
<br /> | <br /> | ||
<br /> | |||
=MICROBEAST PLUS / MICROBEAST ULTRA= | |||
<br /> | |||
The '''servo connector pins must always point towards the front or rear''' of the helicopter. The small white sensor pinboard on the side must always be in line with flight direction.<br /> | The '''servo connector pins must always point towards the front or rear''' of the helicopter. The small white sensor pinboard on the side must always be in line with flight direction.<br /> | ||
<br /> | <br /> | ||
Latest revision as of 11:18, 24 April 2024
Make sure that the mounting platform is perpendicular to the main shaft! On the other hand it's not important that the unit is directly placed on all the rotation axis (which is nearly impossible). Also it's not important that the system is placed in parallel to the ground or not.
MICROBEAST PLUS / MICROBEAST ULTRA
The servo connector pins must always point towards the front or rear of the helicopter. The small white sensor pinboard on the side must always be in line with flight direction.