Translations:Manuals:BXFbl:Radio Setup:RemoteSat/25/en: Difference between revisions
Jump to navigation
Jump to search
Importing a new version from external source |
Importing a new version from external source |
||
(One intermediate revision by the same user not shown) | |||
Line 1: | Line 1: | ||
'''MICROBEAST ULTRA'''<br /> | '''MICROBEAST ULTRA (v5.9.x)'''<br /> | ||
* Disconnect(!) the Spektrum® remote satellite and switch on the power supply. | |||
* Disconnect(!) the Spektrum® remote satellite | * During init sequence (LED light H-N is running) push and hold the button for 4 seconds, then release | ||
* LEDs A and H flash in alternating sequence | |||
* After successful binding procedure the receiver‘s LED will stay solid | * Now connect your remote satellite to the pin board. The receiver's yellow LED will start to flash in combination with LED A on MICROBEAST | ||
* Now you can bind the transmitter as usual (for more information refer to the instructions of your radio control system). | |||
* After successful binding procedure the receiver‘s LED will stay solid | |||
* Your MICROBEAST will restart and enter RECEIVER MENU. Press button briefly to scan for the receiver and proceed. | |||
<br /> | <br /> | ||
<br /> | <br /> |
Latest revision as of 18:39, 30 May 2024
MICROBEAST ULTRA (v5.9.x)
- Disconnect(!) the Spektrum® remote satellite and switch on the power supply.
- During init sequence (LED light H-N is running) push and hold the button for 4 seconds, then release
- LEDs A and H flash in alternating sequence
- Now connect your remote satellite to the pin board. The receiver's yellow LED will start to flash in combination with LED A on MICROBEAST
- Now you can bind the transmitter as usual (for more information refer to the instructions of your radio control system).
- After successful binding procedure the receiver‘s LED will stay solid
- Your MICROBEAST will restart and enter RECEIVER MENU. Press button briefly to scan for the receiver and proceed.