Translations:Manuals:BXFbl:Receiver M/32/en: Difference between revisions

From BEASTX Wiki
Jump to navigation Jump to search
FuzzyBot (talk | contribs)
7,903 edits
Importing a new version from external source
 
FuzzyBot (talk | contribs)
7,903 edits
Importing a new version from external source
 
Line 1: Line 1:
To connect MICROBEAST ULTRA with your JIVE PRO/KOSMIK ESC you need a special type of wire. You can get a ready to use solution from Kontronik® - Ordernr. 9703 (TELEMETRY CABLE JR). As shown below, the telemetry signal pin is the middle pin of the 5-pin connector. The most inner pin is common ground on JIVE Pro ESCs. On KOSMIK the pin next to the "LED side" is common ground. It is highly recommended to use a multimeter and check polarity before connecting your ESC to MICROBEAST ULTRA. Note that the pin on the opposite side carries +5V. Do not connect anything here!<br />
To connect MICROBEAST PLUS / ULTRA with your JIVE PRO / KOSMIK ESC you need a special type of wire. You can get a ready to use solution from Kontronik® - Ordernr. 9703 (TELEMETRY CABLE JR). As shown below, the telemetry signal pin is the middle pin of the 5-pin connector. The most inner pin is common ground on JIVE Pro ESCs. On KOSMIK the pin next to the "LED side" is common ground. It is highly recommended to use a multimeter and check polarity before connecting your ESC to MICROBEAST PLUS / ULTRA. Note that the pin on the opposite side carries +5V. Do not connect anything here!<br />
<br />
<br />

Latest revision as of 11:58, 5 July 2024

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Manuals:BXFbl:Receiver M)
To connect MICROBEAST PLUS / ULTRA with your JIVE PRO / KOSMIK ESC you need a special type of wire. You can get a ready to use solution from Kontronik® - Ordernr. 9703 (TELEMETRY CABLE JR). As shown below, the telemetry signal pin is the middle pin of the 5-pin connector. The most inner pin is common ground on JIVE Pro ESCs. On KOSMIK the pin next to the "LED side" is common ground. It is highly recommended to use a multimeter and check polarity before connecting your ESC to MICROBEAST PLUS / ULTRA. Note that the pin on the opposite side carries +5V. Do not connect anything here!<br />
<br />

To connect MICROBEAST PLUS / ULTRA with your JIVE PRO / KOSMIK ESC you need a special type of wire. You can get a ready to use solution from Kontronik® - Ordernr. 9703 (TELEMETRY CABLE JR). As shown below, the telemetry signal pin is the middle pin of the 5-pin connector. The most inner pin is common ground on JIVE Pro ESCs. On KOSMIK the pin next to the "LED side" is common ground. It is highly recommended to use a multimeter and check polarity before connecting your ESC to MICROBEAST PLUS / ULTRA. Note that the pin on the opposite side carries +5V. Do not connect anything here!

Retrieved from "https://wiki.beastx.com/index.php?title=Translations:Manuals:BXFbl:Receiver_M/32/en&oldid=24996"