Translations:Help:FAQ/21/en: Difference between revisions
Jump to navigation
Jump to search
Importing a new version from external source |
Importing a new version from external source |
||
(One intermediate revision by the same user not shown) | |||
Line 1: | Line 1: | ||
Check very carefully that all cables are plugged in correctly and all the plugs are connected properly at the correct position on both MICROBEAST and receiver side. Especially in the vertical direction make sure not just 2 pins sit on the header. Also make sure that the polarity is correct on all connections. Make sure your power supply (BEC or receiver battery) is capable to power all connected devices (servos, receiver, flybarless). When the power drain is too high this can cause a short drop in voltage making the system resart over and over again.<br /> | |||
Check very carefully | <br /> |
Latest revision as of 11:29, 27 February 2017
Check very carefully that all cables are plugged in correctly and all the plugs are connected properly at the correct position on both MICROBEAST and receiver side. Especially in the vertical direction make sure not just 2 pins sit on the header. Also make sure that the polarity is correct on all connections. Make sure your power supply (BEC or receiver battery) is capable to power all connected devices (servos, receiver, flybarless). When the power drain is too high this can cause a short drop in voltage making the system resart over and over again.