Help:FAQ Spektrum/de: Difference between revisions

Jump to navigation Jump to search
← Older editNewer edit →
Created page with "===Bei Pirouetten im Schwebeflug eiert der Helikopter bzw. kippt zur Seite=== * AR7200BX/AR7300BX: Die Pirouettenoptimierung könnte verkehrt herum eingestellt sein. Prüfen S..."
Created page with "===Beim Versuch vom Boden abzuheben kippt der Heli sofort zu einer Seite weg.=== * Prüfen Sie sämtliche Steuerfunktionen nochmals am Boden genau nach. Bei Eingabe von kollek..."
Line 163: Line 163:
<br />
<br />


===Helicopter tips over when trying to take off or tilts to one side in flight.===
===Beim Versuch vom Boden abzuheben kippt der Heli sofort zu einer Seite weg.===
* Please check whether everything works properly on the ground. When giving collective pitch input the swash should move up and down properly. When giving cyclic input it should return to zero after a few seconds. This is also especially after turning on Idle up or switching between flight conditions in the transmitter. Make sure that there are no trims, mixers, etc. in any flight condition and also make sure that the sensor directions for aileron and elevator are setup correctly ([[Manuals:MB_Plus:Setupmenu_M|Setup menu point '''M''']])!
* Prüfen Sie sämtliche Steuerfunktionen nochmals am Boden genau nach. Bei Eingabe von kollektivem Pitch muss die Taumelscheibe waagrecht stehen bleiben während Sie sich auf und ab bewegt. Werden die zyklischen Steuerfunktionen betätigt und wieder losgelassen, so sollte die Taumelscheibe nach wenigen Sekunden wieder in die Neutrallage zurückfahren. Prüfen Sie nach, ob das in allen Flugphasen der Fall ist oder ob ggf. Mischfunktionen unbeabsichtigt aktiviert werden. In keiner Flugphase dürfen Trimmungen oder Mischer aktiv sein. Prüfen Sie ausserdem die Einstellung der Sensorrichtungen von Roll und Nick nochmals sehr sorgfältig ([[Manuals:MB_Plus:Setupmenu_M/de|Setupmenü Einstellpunkt '''M''']])!


* When taking off do not use too much cyclic input. Just let the motor come up to speed and then quickly give pitch input. Only when the helicopter is airborne the system can operate and control commands. If the helicopter sits on the ground, however, a stick input(= command to rotate the heli) would have no effect and the system would increase the cyclic pitch more and more desperately to perform a rotational movement. As soon as the helicopter will get "light" by increasing the collective pitch it will tip over abruptly. So always make sure that the swash is aligned straight during starting procedure!
* When taking off do not use too much cyclic input. Just let the motor come up to speed and then quickly give pitch input. Only when the helicopter is airborne the system can operate and control commands. If the helicopter sits on the ground, however, a stick input(= command to rotate the heli) would have no effect and the system would increase the cyclic pitch more and more desperately to perform a rotational movement. As soon as the helicopter will get "light" by increasing the collective pitch it will tip over abruptly. So always make sure that the swash is aligned straight during starting procedure!
Retrieved from "https://wiki.beastx.com/index.php?title=Help:FAQ_Spektrum/de"