Translations:Manuals:BXFbl:Radio Setup:RemoteSat/25/en: Difference between revisions

From BEASTX Wiki
Jump to navigation Jump to search
← Older edit
FuzzyBot (talk | contribs)
8,369 edits
Importing a new version from external source
FuzzyBot (talk | contribs)
8,369 edits
Importing a new version from external source
 
Line 1: Line 1:
'''MICROBEAST ULTRA (v5.9.x)'''<br />
'''MICROBEAST PLUS/ULTRA (> v5.9.x)'''<br />
* Disconnect(!) the Spektrum® remote satellite and switch on the power supply.
* Disconnect(!) the Spektrum® remote satellite and switch on the power supply.
* During init sequence (LED light H-N is running) push and hold the button for 4 seconds, then release
* During init sequence (LED light H-N is running) push and hold the button for 4 seconds, then release

Latest revision as of 14:22, 8 September 2026

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Manuals:BXFbl:Radio Setup:RemoteSat)
'''MICROBEAST PLUS/ULTRA (> v5.9.x)'''<br />
* Disconnect(!) the Spektrum® remote satellite and switch on the power supply.
* During init sequence (LED light H-N is running) push and hold the button for 4 seconds, then release
* LEDs A and H flash in alternating sequence
* Now connect your remote satellite to the pin board. The receiver's yellow LED will start to flash in combination with LED A on MICROBEAST
* Now you can bind the transmitter as usual (for more information refer to the instructions of your radio control system).
* After successful binding procedure the receiver‘s LED will stay solid
* Your MICROBEAST will restart and enter RECEIVER MENU. Press button briefly to scan for the receiver and proceed.
<br />
<br />

MICROBEAST PLUS/ULTRA (> v5.9.x)

  • Disconnect(!) the Spektrum® remote satellite and switch on the power supply.
  • During init sequence (LED light H-N is running) push and hold the button for 4 seconds, then release
  • LEDs A and H flash in alternating sequence
  • Now connect your remote satellite to the pin board. The receiver's yellow LED will start to flash in combination with LED A on MICROBEAST
  • Now you can bind the transmitter as usual (for more information refer to the instructions of your radio control system).
  • After successful binding procedure the receiver‘s LED will stay solid
  • Your MICROBEAST will restart and enter RECEIVER MENU. Press button briefly to scan for the receiver and proceed.



Retrieved from "https://wiki.beastx.com/index.php?title=Translations:Manuals:BXFbl:Radio_Setup:RemoteSat/25/en&oldid=26931"