Update request/en

Update files for MICROBEAST, Trajectory and AR7200BX will be created exclusively for your device and mailed to the given address! To request an update the serial number for the device is necessary. Please have a look here, if you don't know where to find the serial number. The update files can be uploaded to the unit by using the update functionality of StudioX. Updating MICROBEAST PLUS can be directly done from within StudioX.

MICROBEAST PLUS

Current firmware version available: 3.2.0

 * supports new SRXL receiver types: Spektrum SRXL and Multiplex SRXL V2
 * added rudder servo sub trim feature
 * changed Status LED colors at Setup menu point M (Sensor directions) to be similar to MICROBEAST version 3.0.12
 * safety feature for Receiver setup menu: to change/setup receiver type and channel assignment you must go through the complete menu otherwise nothing will change

Firmware version 3.1.3

  * Bugfix: receiver channel initialisation could cause unit to start without stick control

MICROBEAST

Request Updates Files for the MICROBEAST here

Current firmware version available: 3.0.12

  * Supports Graupner HOTT SUMD serial line signal
  * Improved receiver channel initialization
  * Improved tailgyro algorithm for normal (rate) mode

Trajectory

Request Updates Files for the Trajectory here

Current firmware version available: 3.0.12 (similar to MICROBEAST)

AR7200BX

Request Updates Files for the AR7200BX here