Manuals:MB Plus:Parametermenu J/de: Difference between revisions
Shornstein (talk | contribs) Created page with "{{TOC_MBPlus/de}} Beim Aktivieren der Drehzahlregelung gibt das System nicht schlagartig Gas, sondern fährt die Rotorkopfdrehzahl langsam hoch bis die gewünschte Vorgabedreh..." |
Updating to match new version of source page |
||
| Line 1: | Line 1: | ||
__NOTOC__ | __NOTOC__ | ||
{{TOC_MBPlus | {{TOC_MBPlus}} | ||
{{DISPLAYTITLE:Parameter menu point J|noerror}} | |||
When activating the RPM Governor this will not apply full throttle immediately but will increase the rotor head speed slowly until the desired preset head speed is reached. At menu point '''J''' you can determine how quickly this soft start occurs when the RPM Governor is activated initially. The speed is given in number of revolutions by how much the rotor speed is increased per second. The higher the speed the faster your preset head speed will be reached. Please note that the given rates only are indicative. Depending on the response of the speed controller and the inertia of the rotor system it can actually take longer or shorter until the desired speed is reached.<br /> | |||
<br /> | <br /> | ||
The choice is made by moving the rudder stick into one direction until the Status-LED lights in the desired color.<br /> | |||
<br /> | <br /> | ||
{{ | {{TABLE|Spool up rate | ||
|50 | |50 rps | ||
|100 | |100 rps | ||
|200 | |200 rps | ||
|300 | |300 rps | ||
|400 | |400 rps | ||
}}<br /> | }}<br /> | ||
The option “user defined” allows you to choose your own setting that can be edited by using the [[StudioX_overview|StudioX software bundle]] and the separately available USB2SYS interface.<br /> | |||
<br /> | <br /> | ||
<br /> | <br /> | ||
---- | ---- | ||
Push the button to save the configuration and to proceed to [[Manuals:MB_Plus:Parametermenu_K|Parameter menu point '''K''']]. | |||
---- | ---- | ||
Revision as of 12:49, 30 September 2015
When activating the RPM Governor this will not apply full throttle immediately but will increase the rotor head speed slowly until the desired preset head speed is reached. At menu point J you can determine how quickly this soft start occurs when the RPM Governor is activated initially. The speed is given in number of revolutions by how much the rotor speed is increased per second. The higher the speed the faster your preset head speed will be reached. Please note that the given rates only are indicative. Depending on the response of the speed controller and the inertia of the rotor system it can actually take longer or shorter until the desired speed is reached.
The choice is made by moving the rudder stick into one direction until the Status-LED lights in the desired color.
| Status-LED | Spool up rate |
|---|---|
| purple | 50 rps |
| red flashing | 100 rps |
| red | 200 rps |
| blue flashing | 300 rps |
| blue | 400 rps |
| off | user defined |
The option “user defined” allows you to choose your own setting that can be edited by using the StudioX software bundle and the separately available USB2SYS interface.
Push the button to save the configuration and to proceed to Parameter menu point K.