Changes

===Der Heli rollt nicht schnell genug über die zyklischen Drehachsen. Kann man dies verbessern?===

===Der Heli rollt nicht schnell genug über die zyklischen Drehachsen. Kann man dies verbessern?===

The roation speed is only determined by the length of the stick signal (and especially has nothing to do with your cyclic pitch adjustment at setup points J or L and also has nothing to do with the cyclic pitch when steering cyclic on the ground!). So increasing/decreasing the stick throw, mostly done by increasing/decreasing servo throw or using Dualrate in the TX for the specified function, will increase/decrease roation rate.

* Im Sender den Servoweg vergrößern oder die Steuercharakteristik "Parameterpunkt B" eine Stufe höher stellen. Falls Expo per Sender dazugemischt werden soll, bitte Punkt B unbedingt auf "blau / Sender" stellen und dann mit reduziertem Servoweg langsam an die gewünschte Einstellung herantasten.

The presets in parameter B are nothing else than different preset dualrate/expo curves inside the MB. When using these it is recommended not to change the output signal in the TX as especially when using expo this will bend, compress or stretch the curves leading to very strange flight behavior (it just is not like adding 5% of expo as the curves between TX and Microbeast will multiply and not sum together!) If you like the feeling of course you can do this. For example a slight increase in stick throw for increasing the roll rate will not significantly deform the Microbeast's internal curve and can be done with no problem. But easiest thing would be to switch flight behaviour to "blue=TX" and adjust the curves in your transmitter as you like (therefor I'd suggest to start with 70% D/R and 25% expo on cylic and 85% D/R and 40% expo on tail). When setting parameter B to "blue = TX" these internal curves in MB will be disabled. So 100% stick should give 100% rotation rate. This may vary depending on TX brand as any manufacturer use another signal output as maximum. So this can be at 107 or 110% or also at 95%. Manufacturers calculate expo curves different, so we can't tell you what our preset curves correspond to which TXs expo values as we use our own expo and there is no data available for comparing. We did outfly these values and programmed them in the source code so we can't tell what these are in Futaba or JR percentages.

The presets in parameter B are nothing else than different preset dualrate/expo curves inside the MB. When using these it is recommended not to change the output signal in the TX as especially when using expo this will bend, compress or stretch the curves leading to very strange flight behavior (it just is not like adding 5% of expo as the curves between TX and Microbeast will multiply and not sum together!) If you like the feeling of course you can do this. For example a slight increase in stick throw for increasing the roll rate will not significantly deform the Microbeast's internal curve and can be done with no problem. But easiest thing would be to switch flight behaviour to "blue=TX" and adjust the curves in your transmitter as you like (therefor I'd suggest to start with 70% D/R and 25% expo on cylic and 85% D/R and 40% expo on tail). When setting parameter B to "blue = TX" these internal curves in MB will be disabled. So 100% stick should give 100% rotation rate. This may vary depending on TX brand as any manufacturer use another signal output as maximum. So this can be at 107 or 110% or also at 95%. Manufacturers calculate expo curves different, so we can't tell you what our preset curves correspond to which TXs expo values as we use our own expo and there is no data available for comparing. We did outfly these values and programmed them in the source code so we can't tell what these are in Futaba or JR percentages.