Translations:Help:FAQ Nanobeast/2/en: Difference between revisions
Importing a new version from external source |
Importing a new version from external source |
||
| Line 1: | Line 1: | ||
= External programming device for nanobeast / Shape S2 heli = | = External programming device for nanobeast / Shape S2 heli = | ||
The Shape S2 helicopter is shipped with a small programming device that has a button and a 3 DIP switches. As the Nanobeast on the Shape S2 is pre-programmed it is not necessary to perform initial setup procedure for the helicopter with the StudioX App. Instead you just have to setup your radio system and start radio system detection on the Nanobeast once. For this the included programming device is used. For further information please see the Shape S2 instruction manual.<br /> | The Shape S2 helicopter is shipped with a small programming device that has a button and a 3 DIP switches. As the Nanobeast on the Shape S2 is pre-programmed it is not necessary to perform initial setup procedure for the helicopter with the StudioX App. Instead you just have to setup your radio system and start radio system detection on the Nanobeast once. For this the included programming device is used. For further information please see the [https://www.beastx.com/download/manual/nanobeast/nanobeastV51_0719_web_EN.pdf Shape S2 instruction manual].<br /> | ||
<br /> | <br /> | ||
FYI: In fact only the push button on the device is needed. The 3 DIP switches are no in use with current firmware and may be used for other programming tasks in future.<br /> | FYI: In fact only the push button on the device is needed. The 3 DIP switches are no in use with current firmware and may be used for other programming tasks in future.<br /> | ||
<br /> | <br /> | ||
Additional note: The programming button can be used in combination with the standard nanobeast firmware in order to initiate automatic receiver scan, too. Please refer to the Shape S2 manual (basically procedure is as follows: connect programmer, power up, push and hold button while LED is flashing red, release when LED goes out, again push briefly to start scan).<br /> | Additional note: The programming button can be used in combination with the standard nanobeast firmware in order to initiate automatic receiver scan, too. Please refer to the [https://www.beastx.com/download/manual/nanobeast/nanobeastV51_0719_web_EN.pdf Shape S2 instruction manual] (basically procedure is as follows: connect programmer, power up, push and hold button while LED is flashing red, release when LED goes out, again push briefly to start scan).<br /> | ||
<br /> | <br /> | ||
Revision as of 09:55, 30 October 2019
External programming device for nanobeast / Shape S2 heli
The Shape S2 helicopter is shipped with a small programming device that has a button and a 3 DIP switches. As the Nanobeast on the Shape S2 is pre-programmed it is not necessary to perform initial setup procedure for the helicopter with the StudioX App. Instead you just have to setup your radio system and start radio system detection on the Nanobeast once. For this the included programming device is used. For further information please see the Shape S2 instruction manual.
FYI: In fact only the push button on the device is needed. The 3 DIP switches are no in use with current firmware and may be used for other programming tasks in future.
Additional note: The programming button can be used in combination with the standard nanobeast firmware in order to initiate automatic receiver scan, too. Please refer to the Shape S2 instruction manual (basically procedure is as follows: connect programmer, power up, push and hold button while LED is flashing red, release when LED goes out, again push briefly to start scan).