Translations:Manuals:MBUltraFblV5:TelemetryInfo/7/en: Difference between revisions
Jump to navigation
Jump to search
Importing a new version from external source |
Importing a new version from external source |
||
| Line 1: | Line 1: | ||
= Futaba SBUS2 = | = Futaba SBUS2 = | ||
Make sure you receiver is set up to send SBUS2 telemetry data. Usually this is done from the LINKAGE MENU of your Futaba radio. Sometimes it is necessary to perform a rebind, in order to activate the telemetry output!<br /> | |||
<br /> | |||
In the SENSOR menu activate the following devices:<br /> | |||
* SLOT 8: rpm sensor (=headspeed) | |||
* SLOTs 9-10-11: CUR-1678 (=voltage, current, consumption) | |||
* SLOT 12: TEMP-1713 (=ESC temperature) | |||
* SLOT 13: TEMP-1713 (=PWM) | |||
<br /> | |||
Please note this assignment is fixed. If you use additional sensors on the same slots, these must be reassigned to other slots.<br /> | |||
<br /> | |||
You can add alarms to each item in the TELEMETRY menu. Please refer to the instructions manual of your radio for further reference.<br /> | |||
<br /> | |||
<br /> | <br /> | ||
Revision as of 14:26, 23 March 2023
Futaba SBUS2
Make sure you receiver is set up to send SBUS2 telemetry data. Usually this is done from the LINKAGE MENU of your Futaba radio. Sometimes it is necessary to perform a rebind, in order to activate the telemetry output!
In the SENSOR menu activate the following devices:
- SLOT 8: rpm sensor (=headspeed)
- SLOTs 9-10-11: CUR-1678 (=voltage, current, consumption)
- SLOT 12: TEMP-1713 (=ESC temperature)
- SLOT 13: TEMP-1713 (=PWM)
Please note this assignment is fixed. If you use additional sensors on the same slots, these must be reassigned to other slots.
You can add alarms to each item in the TELEMETRY menu. Please refer to the instructions manual of your radio for further reference.