Translations:Manuals:BXFbl:Receiver M/14/en: Difference between revisions
Jump to navigation
Jump to search
Importing a new version from external source |
Importing a new version from external source |
||
| Line 1: | Line 1: | ||
'''There are some additional settings for telemetry available:'''<br /> | '''There are some additional settings for telemetry available:'''<br /> | ||
* In GOVERNOR MENU you can use the '''signal divider''' and '''gear ratio''' adjustment to calculate the rotor head speed from the incoming motor speed. Most ESCs will send the electrical motor speed on the telemetry channel only, so you must divide the motor speed by the number of magnet pole pairs and by the main gear ratio of your helicopter, in order to display the rotor speed. See [[Manuals: | * In GOVERNOR MENU you can use the '''signal divider''' and '''gear ratio''' adjustment to calculate the rotor head speed from the incoming motor speed. Most ESCs will send the electrical motor speed on the telemetry channel only, so you must divide the motor speed by the number of magnet pole pairs and by the main gear ratio of your helicopter, in order to display the rotor speed. See [[Manuals:BXFbl:Governormenu_E/en|GOVERNOR MENU E]] and [[Manuals:BXFbl:Governormenu_E/en|GOVERNOR MENU F]] for more details. | ||
* Some ESC do not calculate the current consumption (Hobbywing®, Kontronik® Jive). Here | * Some ESC do not calculate the current consumption (Hobbywing®, Kontronik® Jive). Here your BEASTX system will do the work and calculate the current consumption using the instant current values. Anyhow, results may vary as speed controllers usually measure the motor current but not the battery current. So we added the parameter '''Capacity correction''' which allows to compensate the offset. I.e. when telemetry shows 3600mAh of current consumption, but in reality you did charge 4000mAh back into your battery after the flight, you can increase the Current correction by 10% to 110 in order to get proper reading the next time. Please note this very special value can only be set by using StudioX!<br /> | ||
<br /> | <br /> | ||
Latest revision as of 11:58, 5 July 2024
There are some additional settings for telemetry available:
- In GOVERNOR MENU you can use the signal divider and gear ratio adjustment to calculate the rotor head speed from the incoming motor speed. Most ESCs will send the electrical motor speed on the telemetry channel only, so you must divide the motor speed by the number of magnet pole pairs and by the main gear ratio of your helicopter, in order to display the rotor speed. See GOVERNOR MENU E and GOVERNOR MENU F for more details.
- Some ESC do not calculate the current consumption (Hobbywing®, Kontronik® Jive). Here your BEASTX system will do the work and calculate the current consumption using the instant current values. Anyhow, results may vary as speed controllers usually measure the motor current but not the battery current. So we added the parameter Capacity correction which allows to compensate the offset. I.e. when telemetry shows 3600mAh of current consumption, but in reality you did charge 4000mAh back into your battery after the flight, you can increase the Current correction by 10% to 110 in order to get proper reading the next time. Please note this very special value can only be set by using StudioX!