Translations:Manuals:BXFbl:Receiver A/7/en: Difference between revisions

From BEASTX Wiki
Jump to navigation Jump to search
FuzzyBot (talk | contribs)
8,369 edits
Importing a new version from external source
 
FuzzyBot (talk | contribs)
8,369 edits
Importing a new version from external source
 
Line 1: Line 1:
= NANOBEAST =
= NANOBEAST =
To get into the RECEIVER MENU connect the push button panel to the [SYS] port after turning on the receiver power supply. Now push and hold the button for 2 seconds and release. The Status LED will flash once, indicating Menu Point '''1'''.<br />
Make sure the receiver is connected properly, bound to the radio and sending out signals, and that the transmitter is set up correctly. Espeically make sure the throttle is in lowest position (Motor off/full stop). Since firmware v5.9.11, RECEIVER MENU starts the automatic receiver detection routine on its own after 17 seconds when there is no valid receiver signal detected. The Status LED will indicate the scan process:<br />
<br />
In order to detect the receiver you're using, make sure the receiver is connected properly, bound to the radio and sending out signals. Also make sure the transmitter is setup correctly. Then briefly press the button to start automatic receiver detection routine. The Status LED will indicate the scan process:<br />
<br />
<br />

Latest revision as of 14:12, 8 September 2026

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Manuals:BXFbl:Receiver A)
= NANOBEAST =
Make sure the receiver is connected properly, bound to the radio and sending out signals, and that the transmitter is set up correctly. Espeically make sure the throttle is in lowest position (Motor off/full stop). Since firmware v5.9.11, RECEIVER MENU starts the automatic receiver detection routine on its own after 17 seconds when there is no valid receiver signal detected. The Status LED will indicate the scan process:<br />
<br />

NANOBEAST

Make sure the receiver is connected properly, bound to the radio and sending out signals, and that the transmitter is set up correctly. Espeically make sure the throttle is in lowest position (Motor off/full stop). Since firmware v5.9.11, RECEIVER MENU starts the automatic receiver detection routine on its own after 17 seconds when there is no valid receiver signal detected. The Status LED will indicate the scan process:

Retrieved from "https://wiki.beastx.com/index.php?title=Translations:Manuals:BXFbl:Receiver_A/7/en&oldid=26916"