Translations:Studiox microbeast plus plugin/13/en: Difference between revisions
Importing a new version from external source |
Importing a new version from external source |
||
| Line 1: | Line 1: | ||
=Advanced | =Advanced plug-in configuration= | ||
From the StudioX main menu, open "Edit" then "Configure | From the StudioX main menu, open "Edit" then "Configure plug-ins..." to show the plug-in Configuration dialog.<br /> | ||
Select "MICROBEAST PLUS" from the list:<br /> | Select "MICROBEAST PLUS" from the list:<br /> | ||
<br /> | <br /> | ||
[[File:Mb_config_dlg.png|200px|thumb|none]] | [[File:Mb_config_dlg.png|200px|thumb|none]] | ||
==Serial Port Control== | ==Serial Port Control== | ||
By default the MICROBEAST PLUS | By default the MICROBEAST PLUS plug-in will continuously try to query all serial interfaces (the USB2SYS/SPMA3030-Interface is a serial interface) to check if a MICROBEAST PLUS is connected somewhere.<br /> | ||
Sometimes it is useful to limit the ports that the | Sometimes it is useful to limit the ports that the plug-in is trying to query, i.e. in case a port is blocking the plug-in. Therefore you can choose from one of the following options: | ||
* Use all ports, except those selected | * Use all ports, except those selected | ||
* Only use selected ports | * Only use selected ports | ||
Use the entries in the list below to refine your selection. The | Use the entries in the list below to refine your selection. The plug-in will only try to query ports which match the selected rule.<br /> | ||
==Device Discovery== | ==Device Discovery== | ||
This specifies the interval time which is used to try identifying newly connected devices. This should not be modified if the mechanism is working properly.<br /> | This specifies the interval time which is used to try identifying newly connected devices. This should not be modified if the mechanism is working properly.<br /> | ||
<br /> | <br /> | ||
Latest revision as of 16:04, 17 November 2015
Advanced plug-in configuration
From the StudioX main menu, open "Edit" then "Configure plug-ins..." to show the plug-in Configuration dialog.
Select "MICROBEAST PLUS" from the list:
Serial Port Control
By default the MICROBEAST PLUS plug-in will continuously try to query all serial interfaces (the USB2SYS/SPMA3030-Interface is a serial interface) to check if a MICROBEAST PLUS is connected somewhere.
Sometimes it is useful to limit the ports that the plug-in is trying to query, i.e. in case a port is blocking the plug-in. Therefore you can choose from one of the following options:
- Use all ports, except those selected
- Only use selected ports
Use the entries in the list below to refine your selection. The plug-in will only try to query ports which match the selected rule.
Device Discovery
This specifies the interval time which is used to try identifying newly connected devices. This should not be modified if the mechanism is working properly.