Translations:Manuals:MBUltraFblV5:Radio Setup/3/en

Preparing the receiver

Before using your receiver with MICROBEAST ULTRA make sure that the receiver is bound to the transmitter and that it is sending output data on the servo outputs and/or single-line port. Please refer to the manual of your radio system to find out how binding procedure is performed with your specific system. Also check if there is the need to perform special settings to enable the single-line data output of the receiver in case you intend to use this output port in combination with MICROBEAST ULTRA.

In case of using a single Spektrum® remote DSM2/DSMX satellite receiver directly connected to MICROBEAST ULTRA, you must bind the receiver by the aid of MICROBEAST ULTRA. Here we have no other option to enable binding procedure at the receiver. Please note that it is very important to bind the receiver first before programming MICROBEAST ULTRA and this step must be performed, even if the satellite was already in use and already bound to the transmitter earlier (e. g. in connection with a Spektrum® main receiver unit).