Translations:Help:FAQ/34/en

From BEASTX Wiki
Revision as of 17:45, 24 February 2015 by Shornstein (talk | contribs)
Jump to navigation Jump to search
Note for MICROBEAST/Ar7200BX/Ar7200BX: If Parameter menu point B is set to preset "blue" and the tail
gain is switched to heading lock mode you can see in operation mode by the Status LED state at which tail
stick position the maximum possible rotation rate on rudder will be reached: At that specific tail stick
position the Status LED will start to flash. Moving the stick to this point in flight the rotation rate of
the helicopter will be as high as the gyro can control. Increasing the stick throw further the LED will go
off. At this point the rate control is switched off and the tail will spin freely. Here the only limit is
the tail pitch throw and normaly the tail will spin ultra fast. This can be used for performing tail slides
or turns with very fast spinning tail. For normal flying around you should not use this as you may accidentaly
steer into the uncontrolled area and the tail may spin too fast or very uneven. So please check on the ground
that the Status LED will not go off when giving full rudder stick deflection in your default flight modes.