Translations:Help:FAQ:General/9/en
MICROBEAST PLUS
When updating from firmware 4.x.x or lower to Version 5.x.x you will loose all your settings. Please carefully read the instruction manual for Version 5.x and do the basic setup again.
5.7.0 (not yet released)
- Telemetry (optional/PROEDITION)
- added telemetry data processing for YGE ESC(YGE TEXY protocol)
- added telemetry data processing for Spektrum AVIAN Smart ESC (must be connected at SYS port)
- added telemetry data input for Graupner HOTT receivers (telemetry line must be connected at SYS port)
- capacity correction value now can be used in combination with any telemetry ESC if needed
5.5.2
- Telemetry (optional/PROEDITION)
- added telemetry data processing for Scorpion Tribunus II 14-200 ESC
- added telemetry data processing for Scorpion Tribunus II 14-200 ESC
5.5.1
- Telemetry (optional/PROEDITION)
- added telemetry data processing for Hobbywing Platinum V5 ESC
- added telemetry data processing for Hobbywing Platinum V5 ESC
5.4.0
- Telemetry (optional/PROEDITION)
- added SRXL2 and EXBUS telemetry output
- added telemetry data processing for Hobbywing Platinum V4, Kontronik Jive/Kosmik and Scorpion Tribunus ESCs
5.2.4
- AttitudeControl rescue (optional/PROEDITION)
- added option for automatic rescue deactivation when helicopter reaches level position
- Setup
- menu point ordering has changed in SETUP MENU (H = servo reverse, I = stick directions, J = servo trim, K = cyclic throw, L = collective, M = swash limit)!
- added swashplate trim option to the trim menu at SETUP MENU Point J
- Receivers
- added SRXL2 receiver protocol, can be connected at white pin board on the side
- added option to connect iBus remote receiver (comes with ALIGN T-Rex 300X)
- made ready for telemtry support (coming soon..)
- StudioX
- added help buttons to display help text only when needed
- added screen stacks for adjustment buttons for clearer display layout on smartphones