Translations:Help:FAQ:General/9/en

MICROBEAST PLUS

When updating from firmware 4.x.x or lower to Version 5.x.x you will loose all your settings. Please carefully read the Version 5 instruction manual and do the basic setup again.

5.0.2

Basic functionality

• now fully adjustable (Setup & Parameters) also with StudioX computer software or StudioXm mobile App; see manuals for further information
• added support for FlySky iBus and Jeti EXBUS serial line input data
• removed "User defined" presets instead you can directly edit a value with StudioX/StudioXm if necessary
• reworked adjustment in Receiver Menu:
  • Receiver Menu Point A: automatic receiver type detection; see manual for further information
  • Receiver Menu Point A: changed LED colors for receiver types and also changed receiver type naming; see manual for further information
• reworked adjustment in Setup Menu:
  • in general values and presets are changed using the rudder stick; menu options (selecting servos, changing adjustment positions) are set with aileron; when directions are setup correctly, left stick decreases a value and right stick increases a value
  • Setup Menu Point C (Rudder pulse width): swapped LED colors for 760µs and 960µs (now 760 = purple and 960 = red) so that the values are increasing in the given order from purple (lowest) to blue (highest)
  • Setup Menu Point F (Gyro/Rudder direction): no need to check gyro direction by user anymore, instead teach the rudder direction to the system; see manual for further information
  • swapped Setup Menu Points G and H (now H = Swash servo directions and G = Swash mixing)
  • now supports up to 4 swashplate servos (when choosing 90° eCCPM swash mixing at Setup Point G and using a single wire receiver); 4th servo (2nd elevator) is connected to CH7 output
  • Setup Menu Point J (Cyclic throw): measurement and neutral positions can be selected as often as you like now, so you can even check positions after the setup was finished; see manual for furhter information
  • Setup Menu Point K (Collective pitch): no need to teach the stick end positions anymore, instead the user has to adjust the pitch range initially so the stick movement and range is shown correctly on the display; see manual for further information
  • Setup Menu Point M (Cyclic directions): no need to check swash gyro compensation by user anymore, instead teach the stick directions to the system; see manual for further information
• reworked settings in Parameter Menu:
  • Parameter Menu Point A (Quick trim): added collective trimming and rudder trim can be done with rudder stick now; see manual for further information
  • Parameter Menu Point L (AttitudeControl Mode): swapped LED colors for different modes (now purple = Angular mode, red = Bailout rescue, blue = 3D - Mode)
• throttle failsafe indicator (only when using Single line receiver): when throttle is higher than failsafe position and failsafe engages during power up, the system will lock throttle after initialization and the Status LED will flash red/blue!