All translations
Jump to navigation
Jump to search
Enter a message name below to show all available translations.
Found 2 translations.
| Name | Current message text |
|---|---|
| h German (de) | {{WARNING_QUOTE|Wenn nicht das vorgegebene Steuerverhalten "Linear" verwendet wird, raten wir von einer zusätzlichen Einstellung im Sender ab, da dies zu einer undefinierbaren Vermischung der Steuerkurven von Sender und BEASTX System führt! Eine geringfügige Anpassung im Sender ist aber im Normalfall unproblematisch (z.B. leichte Erhöhung des Steuerausschlags/Servowegs zur Erhöhung der Drehrate).<br /> <br /> [[File:Warning.png|18px|sub]] Wenn der Heckkreisel im Normal-Modus betrieben wird, steuert der Hecksteuerknüppel direkt das Heckservo an, und es wird keine Drehratenvorgabe an den Kreisel gegeben. Das Heck dreht sich hier also so schnell, wie es die Servoposition und der damit verbundene Anstellwinkel der Heckrotorblätter vorgeben. Eine Überwachung der Drehrate durch den Heckkreisel findet nicht statt. Daher können im Normal-Modus extrem hohe Drehraten erreicht werden. Prüfe in diesem Fall unbedingt, wie viel Anstellwinkel am Heck bei Knüppelvollausschlag erreicht wird, und reduziere den Ausschlag über die Fernsteuerung oder begrenze ihn im BEASTX System auf ein vernünftiges Maß.}}<br /> <br /> |
| h English (en) | {{WARNING_QUOTE|When using a predefined control behavior other than "transmitter", we do not recommend additionally adjusting control curves (Expo/Dual rates) in your transmitter, as this will unpredictably mix the preset curves of the BEASTX System with the curves of the transmitter! However, if you only make small adjustments (e.g. slightly increasing the throw to increase the rotation rate), this should not be a problem.<br /> <br /> [[File:Warning.png|18px|sub]] If the tail gyro is operated in Normal-Rate mode, the rudder stick directly controls the rudder servo instead of commanding a rotation rate to the gyro. In this mode the heli will turn as fast as determined by the rudder servo position and angle of attack of the tail rotor blades. The tail gyro does not monitor the rate of rotation. Therefore it is possible to get very high rotation rates, and it is essential to check how much pitch angle is reached at full rudder stick deflection on the tail rotor. Reduce the servo throw of the rudder servo by decreasing it in the remote control, or by limiting it in the BEASTX System to a reasonable level.}}<br /> <br /> |